Garmin Force User & Maintenance Manual page 4

2 Select an action:
• If the rails are in good condition, and you cannot see the
metal mount base though any worn areas, no further
action is needed.
• If the rails are damaged or if you can see the metal mount
base through worn areas in the rails, proceed to the next
step to replace them.
3 Using a 4 mm hex bit or wrench, remove the screws
secure the shrouds to the mount base.
4
Slide the damaged rails off of the mount base.
5
Slide the replacement rails onto the mount base.
6
Secure the shrouds to the mount base using the screws you
removed previously.
Checking and Replacing the Mount Bumper
The mount bumper is the part of the mount base that overhangs
the bow of the boat.
1
Place the motor between the stowed and deployed positions,
and check the mount bumper for damage.
2
Select an action:
• If the mount bumper is undamaged, no further action is
needed.
• If the mount bumper is damaged, proceed to the next step
to replace it.
3
Using a 4 mm hex bit or wrench, remove the two screws that
secure the mount bumper to the mount base.
4
4
Install a replacement mount bumper, and secure it to the
mount base using the screws provided with the replacement
part.
Replacing the Propeller
If the propeller is damaged, you must replace it.
1 Using a 15 mm socket, remove the nut
propeller.
that
2
Remove the lock washer
damaged propeller
3 Service the anode, if necessary
page 3).
4
If necessary, install the pin
5
Install a replacement propeller.
6
Place the anode, flat washer, lock washer, and nut onto the
end of the motor shaft.
7 9
Using a / in (15 mm) socket, tighten the nut to 8.13 N-m
16
(6 lbf-ft) to secure the propeller.
Fixing Paint Scratches
Over time, parts of the motor may become scratched or dinged.
You can use paint to touch up these areas for cosmetic
purposes.
1 Using isopropyl alcohol, throughly clean the areas where the
paint has been scratched or damaged.
2
Apply liquid polyurethane touch-up paint to the scratched or
damaged areas.
3
Follow the instructions on the paint, and allow for proper
drying before using the motor.
Service Parts
You can use these diagrams to identify and order service parts.
You can follow the links where provided for detailed disassembly
and replacement procedures.
To order the service parts listed in this manual, contact Garmin
at 1-800-800-1020 or go to
order using email.
that secures the
, flat washer , anode
.
(Servicing the Anodes,
in the propeller motor shaft
support.garmin.com to place an
, and
.
®