Garmin Force User & Maintenance Manual page 13

When replacing the transducer, you should dispose of these
four screws. New screws, washers, and O-rings are provided
in the shaft and motor hardware service kit.
3
Straighten the cables at the top of the shaft, and slowly pull
the propeller drive motor away from the shaft base until you
can see the power and data cables
propeller drive motor.
4
Holding the cables only, slowly pull them through the shaft,
taking care that the ring terminals and data cable connector
do not get caught on the top of the shaft.
When removing the propeller drive motor from the shaft, you
must pull the cables themselves, and not the motor. Pulling
on the propeller drive motor may damage the cable
connections inside the motor.
The power and data cables should pull through the shaft, but
the transducer cable should mostly stay in place.
Removing the Nose Cone and Transducer
Before you can remove the nose cone and transducer, you must
remove the propeller drive motor
Motor, page 12).
1
Carefully pull the transducer cable
the bottom of the shaft until it is completely removed from the
shaft.
2
After you pull the transducer cable out of the shaft, pull it
through the hole in the front of the shaft base
the rubber cable gland and the recessed nut.
3 Dispose of the cable gland and recessed nut.
connected to the
NOTICE
(Removing the Propeller Drive
straight down through
, along with
The shaft and motor hardware service kit contains a new
cable gland and recessed nut.
Disassembling the Nose Cone
Before you can disassemble the nose cone, you must remove
the skeg and nose cone from the propeller drive motor
(Removing the Skeg and Nose Cone, page
1
Using a 3 mm hex bit or wrench, remove the six screws that
secure the transducer to the nose cone.
2
Remove the transducer and transducer pad from the nose
cone.
If you are not replacing the transducer, you should keep the
transducer pad and six screws so you can secure the
transducer to the replacement nose cone.
Replacing the Nose Cone
Before you can replace the nose cone, you must disassemble
the nose cone (Disassembling the Nose Cone, page
1
Place the transducer pad
2
Using a 3 mm hex bit or wrench, secure the transducer to the
nose cone using the six screws and bushings
3
Install the nose cone and skeg on the shaft
Nose Cone and Skeg, page
Installing the Propeller Drive Motor in the Shaft
You must perform these actions to reassemble the propeller
drive motor in the shaft.
The screws, replacement seals, and grease packet are included
in the motor hardware service kit (S00-01000-35). You should
use the new parts from the kit instead of reusing the screws and
seals you removed with the propeller drive motor.
1
Install the nose cone and transducer in the shaft
the Nose Cone and Transducer in the Shaft, page
2
Install the propeller drive motor on the shaft
Propeller Drive Motor, page
12).
13).
on the transducer.
.
(Installing the
15).
NOTICE
(Installing
14).
(Installing the
14).
13