Portion To Which Locktite Is Applied - JUKI LS-1340 Manual

5. PORTION TO WHICH LOCKTITE IS APPLIED

LOCKTITE has been applied to the following parts at the time of assembly at the factory.When an assembly
which includes the aforementioned parts has been disassembled, be sure to wash the LOCKTITE applied
part using a paint thinner or the like, and re-assemble it using LOCKTITE after removing any moisture from
the mating faces.
If it is hard to remove a part which has been fixed using LOCKTITE, heat it using a torch lamp or the like to
help remove the part.
No. Portion to which LOCKTITE is applied
1 Alternate dial shaft bushing
2 Vertical change base arm pin
3 Feed adjusting rod hinge screw
4 Verticsal change base support shaft screw
5 Thread release bar
(Caution) Avoid disassembling these parts to the most.
No.1
Alternate dial shaft bushing
Top cover B
No.3
Feed adjusting rod
LOCKTITE applied
Feed adjusting rod
hinge screw
No.5
Thread release bar
LOCKTITE applied
LOCKTITE
applied
Fedd adjusting
base
Thread release bar coupling
Thread release bar coupling nut
−
Part No.
10715100
10715308
SD0800402TP
21337803
21441209
No.2
Vertical change
base arm pin
No.4
Setscrew
44
−
LOCKTITE No.
LOCKTITE #638
LOCKTITE #638
LOCKTITE #638
LOCKTITE #243
LOCKTITE #243
LOCKTITE
applied
Vertical adjusting
arm
LOCKTITE
applied
Vertical change base
support shaft