Adjustment Procedures
Deleted parts
Name of part
Part No.
1
Eyelet
US00050392T
™ Remove eyelet !2 and install spreader thread guide !3 .
™ Adjust the vertical position of the spreader thread guide so
that the relation between the thread hole position of auxiliary
thread take-up thread guide !4 and the spreader thread guide
! 3 is as shown in the figure at the time of the lowest point of
the needle bar.
6. OTHER PRECAUTIONS
(1) Points to which Locktite is applied
Added parts
Name of part
Part No.
2
Spreader thread
US0050392BG
guide
68
−
−
Results of Improper Adjustment
The hole on the left-hand side of the
spreader thread guide :
<When general thread is used>
Use the hole located on the lower
side.
<When stretchy thread is used>
Use the hole located on the upper
side.
Locktite 222
Auxiliary take-up thread guide