Remote Control - Lincoln Electric Ranger 330MPX Operator's Manual

RANGER ® 330MPX

REMOTE CONTROL

All weld modes support using a remote control like K857-1. Plug
the remote into the 6 pin connector on the front of the machine.
Press the remote button on the display to toggle between control
at the remote and control at the knob on the machine. The remote
button does not function when welding is occuring.
When a CrossLinc device is connected, the remote control is
ignored. Use the CrossLinc device to remotely set values.
When the remote is enabled, a bar will appear underneath the
preset value showing the remote range. The standard range
allows the remote to adjust from the minimum to the maximum
value of the machine.
Frequently the entire output range is not
required for a weld procedure. To limit
the range of the remote, press the knob
to enter the Options screen and select
Remote Control Range.
Remote
Control
Range
10-22
Press knob
to modify values
?
With the new settings, the sensitivity of
the remote is increased.
124
F A
½
E
Press knob
Remote
for options
ON
?
Rotate the knob to adjust the maximum
value for the remote control. The gray
bar will change size to show the usable
range. The restricted range is shown as
a thin red bar. Press the knob to select
the value.
30
The usable range is shown
as a thick grey bar. The
restricted range is shown
as a thin red bar.
Output
ON
Hot Start
+7
Arc Force
OFF
Gray bar
F
shows
½
remote
range
E
Set MAXIMUM for
Remote Control
160
A A
Press knob to select
?
Maximum
value
Thicker bar shows remote range. Thin
bars show total range. Red and green
sections show recommended range.
124
F
½
E
Remote
ON
B-8
124
Output
A
ON
Hot Start
+7
Arc Force
OFF
Press knob
Remote
for options
ON
?
Rotate the knob to adjust the minimum
value for the remote control. The gray
bar will change size to show the usable
range. The restricted range is shown as
a thin red bar. Press the knob to select
the value.
100 160
A
Press knob to select
Minimum
value
Output
A ON
Hot Start
+7
Arc Force
OFF
Press knob
for options
?
OPERATION
A
?