Table of Contents
Advertisement
To check the remaining length of time
after sleep timer is activated
Press SLEEP once.
Setting the timer
The system can switch on to CD, TUNER, or
MP3 LINK mode automatically at a preset time,
serving as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that the
clock is set correctly.
– The timer will always be switched on
after it has been set.
– The timer will not start if a recording is in
progress.
– The volume of the timer will increase
gradually from the minimum level to the
last tuned volume level (If the last tuned
volume level is less than 15, it will increase
gradually from the minimum level to 15).
1
Press TIMER on the remote control.
The last timer setting is shown.
2
Press TIMER again for more than 2 seconds.
Press PRESET +/- í / ë ( í / ë on the re-
3
mote) to set the hours.
4
Press TIMER again.
Press PRESET +/- í / ë ( í / ë on the
5
remote) to set the minutes.
6
Press TIMER
The timer is now activated and display shows
.
Note:
– If the last selected source is MP3-LINK/AUX, you
cannot use the remote control to set the timer.
Clock/Timer
To deactivate the timer,
Press TIMER in active or standby mode.
disappears if the timer is deactivated.
Notes:
– When the preset time is reached, the last
selected source will be played automatically.
– During timer setting, if no button is pressed
within 10 seconds, the system will exit timer setting
mode automatically.
– If remote control is used, timer/clock setting is
available only in CD and TUNER modes.
17
Advertisement
Table of Contents
