Table of Contents
Advertisement
General Information
Congratulations on your purchase and
welcome to Philips!
Philips offers, register your product at
www.philips.com/welcome
Supplied accessories
– 2 speaker boxes
– remote control
– MP3 link cable
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet).
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
Notice of compliance
The set complies with the FCC-Rules, Part
15 and with RSS-210 of Industry Canada.
Operation is subject to the following two
conditions:
1.This device may not cause harmful
interference, and
2.This device must accept any interference
received, including interference that may cause
undesired operation.
The making of unauthorized copies of
copy-protected material, including computer
copyrights and constitute a criminal offence.
purposes.
8
Safety information
Before operating the system, check that the
operating voltage indicated on the typeplate
(or the voltage indication beside the voltage
.
selector) of your system is identical with the
voltage of your local power supply. If not,
please consult your dealer.
surface.
Place the system in a location with adequate
ventilation to prevent internal heat build-up in
your system. Allow at least 10 cm (4 inches)
clearance from the rear and the top of the unit
and 5 cm (2 inches) from each side.
The ventilation should not be impeded by
covering the ventilation openings with items,
such as newspapers, table-cloths, curtains, etc.
Do not expose the system, batteries or discs to
excessive moisture, rain, sand or heat sources
caused by heating equipment or direct sunlight.
should be placed on the apparatus.
be placed on the apparatus.
The apparatus shall not be exposed to dripping
or splashing.
Install this unit near the AC outlet and where the
AC power plug can be reached easily.
If the system is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lens of the disc
unit inside the system. Should this occur, the CD
player would not operate normally. Leave the
power on for about one hour with no disc in the
system until normal playback is possible.
The mechanical parts of the set contain
self-lubricating bearings and must not be
oiled or lubricated.
When the system is switched to Standby
mode, it is still consuming some power.
To disconnect the system from the
power supply completely, remove the AC
power plug from the wall socket.
Advertisement
Table of Contents
