Graco G3 Instructions Manual page 7

Reservoir Installation - 2 Liter Models Only
1. Grease new o-ring (3) (included in kit) and install
o-ring in ricer plate groove (c) (F
3
c
F . 16
IG
2. Install reservoir (a) with vent (m) facing toward the
rear left (n) of the G3 base. See F
orientation of these parts to ensure proper installa-
tion.
m
a
n
F . 17
IG
3. Position strap wrench over reservoir and use it to
turn reservoir 1/4 turn clockwise till reservoir will not
turn any farther.
NOTICE
Be careful when installing reservoir that o-ring is not
pinched. If the o-ring is not correctly installed,
grease could leak out of the bottom of the G3 reser-
voir.
3A0535C
Reservoir Installation - 4 Liter and Larger
Models Only
. 3).
IG
1. Grease new o-ring (3) (included in kit) and install
p
. 17 for correct
IG
F
1. Install reservoir onto adapter. Position strap wrench
o-ring around reservoir adapter (p) as shown in
(F . 18).
IG
. 18
IG
around lower portion of reservoir as indicated in F
19 and use it to turn the reservoir clockwise to
tighten it to the base.
To ensure the reservoir is tightened sufficiently, but
not over tightened:
a. First turn reservoir clockwise one full turn.
b. Then continue to turn the reservoir clockwise for
a second turn until the vent (q) in the reservoir
faces the back of the G3 pump and the horizon-
tal lines (r) molded into the reservoir align with
the pump outlets (s) on each side of the pump
base as shown in F
Instructions
3
ti16430
. 19.
IG
.
IG
7