Install Drain - Kohler Finial K-20012T-CP Installation Instructions Manual

然后拔去软管头部的保护套，将软管（7）
插入阀体出水口快速夹头中。注意主阀体
组件与墙面保持平行，与角阀连接牢固，
软管插到夹头底部，如果没有插到底易漏
水。
注意：建议在连接供水时,在供水管上
连接一个临时橡皮或塑料软管，冲洗
供水管道，确保水干净，管道内无沙
石、垢物等。
三 安装排水组件
旋下排水器盘片(12)，在其底面沿
周围涂上一圈密封油灰。把排水
本体(13)由底下插入面盆。
把排水器盘片(12)旋入排水本体
(13)。从下方用手拧紧锁紧螺母
(14)，去除多余的油灰。
注意：
在锁紧螺母(14)拧紧后，不
可再调整排水本体的位置，否则将
会破坏油灰密封。
把尾管(15)接上存水弯(16)，尾管需
插入存水弯25mm到55mm之间。
四 安装直流电源盒
1. 取出电池盒组件， 旋松螺钉
（17），按电池盒盖（18）上的正
负极标示装入4节5号电池，紧锁电
池盒盖（18）的螺钉（17）后。
注意：电池极性不能装反，新旧
电池不能混用。
2. 在合适的位置打孔，打入膨胀管，
用自攻螺钉固定电池盒。将相同颜
色接插件分别连接。
注意：接插件位置朝上。
6
Apply plumber's
putty
涂油灰
1
1
17
18
then remove hose protector, insert hose (7)
into valve outlet quick connector. Pay
attention to valve assembly as it must be
parallel to the wall. For a good valve
connection, insert the hose into the bottom
of connector; otherwise a leakage problem
may occur.
NOTE: It is recommended to attach a
temporary rubber or plastic hose to the
supply hose, and then flush the hose
to remove dirt and debris.
12

Install Drain

Unscrew the drain flange (12) and apply
plumber's putty to its underside. Insert the
13
drain body (13) to the lavatory from below.
Thread the drain flange (12) onto the drain
body (13). Tighten the locknut (14) by
12
hand from below. Remove excess putty.
14
NOTE: Do not change the position of the
13
drain after the locknut(14) is tightened, is
tightened as doing so will cause damage
to the putty seal.
Connect the tailpiece(15) to the trap(16).
The tailpiece should extend 25mm to
55mm into the trap.
4. Install DC Power Unit
1. Take out battery case assy., and
loosen the screws(17). Place 4 AA batteries
into the battery case according to negative
and positive electrode marks on the battery
case cover(18). Tighten the screws on the
battery case cover(18).
NOTE: do not mistake the battery electrodes,
and do not use the new and used batteries
together.
2. Determine the installation location of
battery case per rough-in.
Drill holes and place sheath in it. Secure the
battery case with self-tapping screws and
connect each colored connector to the
corresponding connector of the same color.
NOTE: Connectors shall face up.
1293596-T01-A