Kohler Finial K-20012T-CP Installation Instructions Manual page 8

1. (
2.
AC
DC
AC
如何转换成混水感应龙头
(若用户另购三通进水软管
组件1284583-SP)
三通进水软管组件
Tee, Inlet Assy.
8
)
0.3 mm m 2
( )
2分钟
≤400
用户自备角阀G1/2外螺纹
Please prepare external
thread angle valve G1/2
1. AC power unit (sticker on the back) should be installed in a
dry place away from water. Customer should prepare wire
tube and wire according to their requirement. Wire tube should
be mounted into the wall. Suggested wire: AC connection
0.5mm 2
wire adopts wire with protecting layer or sleeve and the section
should be ≥ 0.5mm . The section of DC connection wire
should be ≥ 0.3mm . The connection pattern must follow the
illustrations above.
2.After wire layout finished, check and repair if needed.
Then connect AC connector to AC connector within FPC
pipe, DC connect or (black-orange) on electrical box to
faucet power cord connector (wire from valve
box). Finally turn on AC power source.Faucet will commence
auto-sense mode which will take 2minutes. The faucet will
not work during this period.
HOW TO CHANGE TO A MIXING SENSOR
FAUCET (If customerpurchases tee inlet
assy 1284583-SP)
2
2
1293596-T01-A
s