Table of Contents
Advertisement
0 0 1
believes that it falls in the domestic range.
0 1 0
the user sends a message to a domestic telephone set.
0 1 1 A specific number in this network. It is used for management or service and
cannot be selected by the user.
1 0 1
currently.
1 1 0
1 1 1
Numbering-plan-identification(bit3...bit0). The values are as follows:
(Note: It is valid only when the values of bit6...bit4 are 000, 001, 010. In other
circumstances, bit3...bit0 are not valid)
0 0 0 0
0 0 0 1
0 0 1 1
0 1 0 0
1 0 0 0
1 0 0 1
1 0 1 0
<numbers>: Address number. One byte contains two digits. Bit3~bit0 contain the first
digit, and bit7~bit4 contain the second digit. Coding sequence of half bytes, as shown
in the following example:
n+1
n+2
n+3
Figure 5-1
Note: If the number length is an odd number, the highest four digits of this octet should
be filled with 1111.
'*': 1010
'a': 1100
For example:
If the number of SCA is 13902900, then the <numbers> is: 31099200
Issue 18 (2009-06-22)
This value is selected if the user knows that it is an international number, or
Domestic number. No prefix or suffix is allowed. This value is selected when
The number type is the default 7bit code mode of GSM. It is not in use
Short number. It is not in use currently.
Reserved for extension. It is not in use currently.
The number is determined by the numbering plan at the network side.
ISDN/telephone numbering plan.
Data numbering plan, not in use currently.
Telex numbering plan, not in use currently.
National numbering plan, not in use currently.
Private numbering plan, not in use currently.
ERMES numbering plan, not in use currently.
Digit 2
Digit 4
1
1
1
1
Half byte coding with a total of 5 digits
'#': 1011
b': 1101
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Digit 1
Digit 3
Digit 5
'c': 1110
Page 76 of 169
Advertisement
Table of Contents
