Table of Contents
Advertisement
%CURC?
%CURC=?
11.2.2 Interface Description
The SET command is used to set mode value to open or close unsolicited reports.
The unsolicited reports it can control are listed below: %DSFLOWRPT, %RSSI,
%MODE, %SIMST, %SRVST, %MODE, %EARST, %SMMEMFULL. The unsolicited
reports are closed if the mode value is set to 0 and the unsolicited reports are open if
the mode value is set to 1. The default value of mode is set to 0. So, "%CURC=1"
should be executed if all the unsolicited reports need to be open.
The READ command returns the current mode value.
The TEST command returns the value range it supports.
Unsolicited report is disabled after reset.
11.2.3 Defined Values
<mode>:
0
1
11.3 Service state change indication %SRVST
11.3.1 Command Syntax
Command
11.3.2 Description
When the service state changes, the MS will report the new service state to the TE.
11.3.3 Defined Values
<srv_status>: System service state. The values are as follows:
0
1
2
3
Issue 18 (2009-06-22)
the unsolicited reports closed (default value)
the unsolicited reports open
No service.
Restricted service.
Valid service
Restricted regional service.
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
<CR><LF>%CURC:<mode><CR><LF><CR><LF>OK<C
R><LF>
<CR><LF>%CURC:
<mode>s)<CR><LF>
<CR><LF>OK<CR><LF>
Possible response(s)
<CR><LF>%SRVST:<srv_status><CR><LF>
AT Command Interface Specification
(list
of
Page 118 of 169
supported
Advertisement
Table of Contents
