Table of Contents
Advertisement
13.11.1 Command Syntax
Command
%IPAUTOCON
13.11.2 Description
When the first parmeter of %IPCFL is 0, the autoconnection after reset is disable.
In this case, we can use this command to start autoconnect.
Note: the parameter of %IPCGDCONT, %IPCTRIP must be set.
13.12 PDP environment setting command
%IPCGDCONT
13.12.1 Command Syntax
Command
%IPCGDCONT=<cid>[,<P
DP_type>[,<APN>[,<PDP_
addr>[,<d_comp>[,<h_com
p>]]]]]
%IPCGDCONT?
%IPCGDCONT=?
13.12.2 Description
A group of setting environments indexed by <cid> are stored locally. Each stored
setting environment contains a group of parameters related to PDP. The SET
command stores a group of PDP-related parameters to the setting environment
indexed by <cid>. Initially, each setting environment is not defined. After a group of
parameters are stored via the SET command, the setting environment enters the
"defined" state. The number of defined setting environments that can be stored
depends on the value range of <cid>.
Issue 18 (2009-06-22)
Possible response(s)
<CR><LF>OK<CR><LF>
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>%IPCGDCONT:
<APN>,<PDP_addr>,
<h_comp>[<CR><LF>%IPCGDCONT:
<PDP_type>,
<h_comp>[...]]<CR><LF><CR><LF>OK<CR><LF>
<CR><LF>%IPCGDCONT:
<cid>s),
<d_comp>s),(list of supported <h_comp>s)
[<CR><LF>%IPCGDCONT: (range of supported
<cid>s),
<d_comp>s),
(list
<h_comp>s)[...]]<CR><LF><CR><LF>OK<CR><LF>
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
<cid>,
<APN>,<PDP_addr>,
(range
<PDP_type>,,,(list
<PDP_type>,,,(list
of
<PDP_type>,
<d_comp>,
<cid>,
<d_comp>,
of
supported
of
supported
of
supported
supported
Page 138 of 169
Advertisement
Table of Contents
