10
10.1 Phonebook memory selection +CPBS
10.1.1 Command Syntax
Command
+CPBS=<storage>
[,<reserved>]
+CPBS?
+CPBS=?
10.1.2 Description
The SET command is used to select a phonebook memory. The initial value after
restarting the MS is "SM". Other phonebook-related commands will be operated by
using the memory selected via this command.
The READ command returns the currently selected phonebook memory. Optionally,
the number of entries in use and the maximum number of entries should also be
returned.
The TEST command returns the supported phonebook memory types.
10.1.3 Defined Values
<storage> : Phonebook memory type. Currently, only "SM","ON","EN" are supported.
Issue 18 (2009-06-22)
Phonebook Service Interface
Possible response(s)
<CR><LF>OK<CR><LF>
In case of MS-related error:
<CR><LF>+CME ERROR: <err><CR><LF>
<CR><LF>+CPBS:
<storage>[,<used>,<total>]<CR><LF><CR><LF>OK<CR><
LF>
In case of MS-related error:
<CR><LF>+CME ERROR: <err><CR><LF>
<CR><LF>+CPBS:
<storage>s)<CR><LF><CR><LF>OK<CR><LF>
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Description
(list
of
supported
Page 113 of 169