Command Syntax; Description; Defined Values; Smsc Number Command +Csca - Huawei EM770W At Command Interface Specification

5.11.1 Command Syntax

Command

5.11.2 Description

When the message storage media overflow, the event will be reported automatically.

5.11.3 Defined Values

<mem_type>:
String value. It indicates the type of the overflowing media.
"SM", which means the (U)SIM card. (Status will not be reported because of the
custom-built requirement of Maxon. The oldest message which stored in SM will be
replaced by the new message automatically if SM is full. So there is no
"SMMEMFULL" report.)
"ME", which means NV

5.12 SMSC number command +CSCA

5.12.1 Command Syntax
Command
+CSCA=<sca>[,<tosca>]
+CSCA?
+CSCA=?
5.12.2 Description
The SET command is used to set the SMSC number. For the message in the PDU
mode, the setting of this command can be used only if the SMSC-related parameter
sc_len has the value of 0 (for the PDU format, see the "+CMGS" command) in the
PDU.
5.12.3 Defined Values
<sca>:
Issue 18 (2009-06-22)
Possible response(s)
<CR><LF>%SMMEMFULL:<mem_type><CR><LF>
Possible response(s)
<CR><LF>OK<CR><LF>
In case of MS-related error:
<CR><LF>+CME ERROR: <err><CR><LF>
<CR><LF>+CSCA:
<sca>,<tosca><CR><LF><CR><LF>OK<CR><LF>
In case of MS-related error:
<CR><LF>+CME ERROR: <err><CR><LF>
<CR><LF>OK<CR><LF>
Commercial in Confidence
HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Page 73 of 169