Power Button Board - HP OMEN Maintenance And Service Manual

Power button board

Table 6-11 Power board button description and part number
Description
Power button board
Before removing the power button board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the base enclosure (see
3. Remove the battery (see
4. Remove the hard drive (see
5. Remove the solid-state drive (see
6. Remove the power connector cable (see
7. Remove the fans (see
8. Remove the system board (see
Remove the power button board:
1. Remove the two Phillips 3 mm screws (1) that secure the power button board.
2. Disconnect the power button board cable (2).
3. Remove the power button board (3) from the computer.
Reverse this procedure to install the power button board.
(Preparation for disassembly on page
Base enclosure on page
Battery on page 45).
Hard drive (HDD) on page
Solid-state drive (SSD) on page
Power connector cable on page
Fans on page 48).
System board on page
34).
34).
37).
39).
50).
53).
Component replacement procedures
Spare part number
L14374-001
61