Tuner; Tuning To Radio Stations; Programming Radio Stations; Tuning To Preset Radio Stations - Philips MC-30/25 User Manual

Tuner

STANDBY-ON
iR
M C - 3 0 M I C R O S Y S T E M
SHUFFLE FWD á/ë
RDS/CLOCK SIDE A/B SOURCE
TUNING
REPEAT
TIMER ON•OFF PROGRAM REW à /í REV MODE/ BAND

Tuning to radio stations

1
Select TUNER source.
➜ TUNER is displayed briefly.
2
Press BAND once or more to select your
waveband.
Press down on TUNING 3 or 4 and release
3
button.
➜ The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning: SEARCH.
➜ If a FM station is received in stereo,
shown.
4
Repeat step 3 if necessary until you find the
desired station.
¶ To tune to a weak station, press TUNING 3 or
4 briefly and repeatedly until you have found
optimal reception.

Programming radio stations

You can store up to a total of 40 radio stations
in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden. The system will only programme
stations which are not in the memory already.
Press PRESET 4 or 3 ( ¡ or ™ on the
1
remote control) to select the preset number
where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
14
pg 001-021/MC30/22-Eng
2
1
STOP PLAY•PAUSE
PRESET
2
VOLUME
RECORD
3
4
5
¶ You can override a preset station by storing
is
STEREO
¶ Press PRESET 4 or 3 ( ¡ or ™ on the
¶ Press RDS briefly and repeatedly to scroll
14
Press PROGRAM on the system or remote
control for more than 2 seconds to activate
programming.
➜ AUTO is displayed and available stations are
programmed in order of waveband reception
strength: FM followed by MW and LW. The last
preset automatically stored will then be played.
Manual programming
Tune to your desired station (see Tuning to radio
stations).
Press PROGRAM on the system or remote
control to activate programming.
➜
flashes in the display.
PROGRAM
Press PRESET 4 or 3 (¡ or ™ on the remote
control) to allocate a number from 1 to 40 to
this station.
Press PROGRAM again to confirm the setting.
➜
disappears, the preset number and
PROGRAM
the frequency of the preset station are shown.
Repeat the above four steps to store other
stations.
another frequency in its place.
Tuning to preset stations
remote control) until the desired preset station
is displayed.

RDS

(some versions only)
Radio Data System is a service that allows
FM stations to show additional information. If
you are receiving a RDS station,
station name are displayed.
When automatic programming is used, RDS
stations will be programmed first.
Scrolling through different RDS
information
through the following information (if available):
– Station name
– Programme type such as NEWS, SPORT,
POP M ...
– Radio text messages
– Frequency
12/7/00, 1:33 PM
and the
3140 115 27913