Table of Contents
Advertisement
TUNER
Tuning to radio stations
1 Press SOURCE (or TUNER on the remote control) to
select TUNER.
2 Press BAND to select the desired waveband: FM or
AM.
3 Press TUNING K^or^VI for more than one
second.
The display will show '5ERRCH' until a station with
sufficient signal strength is found.
• Repeat this procedure until the desired station is
reached.
• To tune to a weak station, briefly press TUNING
or
until the display shows the right frequency
and/or when the best reception has been obtained.
Storing Preset Stations
You can store up to 20 stations in the memory. When a
preset station is selected, the preset number appears next
to the frequency on the display.
Automatic programming
1 Press BAND to select the desired waveband: FM or
AM.
2 Press AUTO PROGRAM for more than one second to
start the automatic programming.
PROGRAM flashes and 'BUTO' is displayed.
Every available station will be stored automatically.
The frequency and preset numberwill be displayed
briefly.
-* It will stop searching when all the available stations
are stored or when 20 preset stations are stored.
• You can cancel the automatic programming by pressing
AUTO PROGRAM; TUNING
or
PRESET
T
or A; or BAND.
Note:
If you want to resen/e a section of preset numbers, for
example preset numbers 1-9, select preset 10 before
starting automatic programming. Now only the preset
numbers 10 to 20 will be programmed.
Manual programming
1 Press AUTO PROGRAM for less than one second,
PR
0
GRA
^.1
flashes on the display.
2 Press BAND to select the desired waveband: FM or
AM.
3 Press TUNING 14^or^^I to tune to the desired
frequency.
4 Press PRESET
T
or
A
to select a preset number.
5 Press AUTO PROGRAM again.
PROGRAM
disappears, and the station is stored.
• Repeat the above procedure to store other preset
stations.
Tuning to Preset Stations
• Press PRESET
T
or
A
(M or W on the remote
control) to select the desired preset number.
The preset number, frequency and waveband appear
on the display.
15
Advertisement
Table of Contents
