Securing Your Child; Adjusting The Shoulder Harness Position - Nuna mixx2 Instructions Manual

Securing Your Child

WARNING
from falling or sliding out. Always use the seat belt.
1
- To unfasten the buckle, push on center button and
remove the clips.
2
- To secure child, insert waist strap clips to harness strap
clips then insert into the center buckle until it clicks.
3
- To tighten harness around your child for a snug fit, slide
the adjusters on the straps. For a snug fit, the space
between the child and the shoulder harness should be
about the thickness of one hand.
Adjusting the Shoulder
Harness Position
4
- Accessing the shoulder harness varies by model. To
adjust the position of the shoulder harness anchor, either
open the zipper on the seat back, or unfasten the snaps
located behind the storage pocket and lift up the flap.
Turn the harness anchor to fit through the harness slot.
Push retainer through to front of the seat.
5
- From front of seat, unfasten the snap at the top of the
seat pad and pull the harness strap through the seat
pad.
6
- Re-insert the harness strap through the desired set of
harness slots in the seat pad and seat back that are
closest to your child's shoulders. Repeat with other strap.
CHECK to MAKE SURE that you have inserted the
harness straps through the same set of harness slots
for each harness strap.
Depending on model, either zip the zipper on the seat
back, or close the flap and refasten the 4 snaps to the
back of the seat.
16
Avoid serious injury
1
2
3
4
5
6
17