Assembling The Rear Wheels And Storage Basket; Assembling The Armbar - Nuna mixx2 Instructions Manual

Assembling the
Rear Wheels and Storage Basket
1
- MAKE SURE the brake lever is facing up before
attaching to frame. Push brake assembly onto the rear
leg tubes until it clicks into place.
CHECK that brake assembly is securely attached by
pulling on it.
2
- Line up the tab on the wheel axle with the groove in
the brake assembly and push rear wheel onto the
brake assembly until it clicks into place. Repeat with
the other wheel on other side of brake assembly.
CHECK that wheels are securely attached by pulling
down.
3
- To remove rear wheel, press the button
wheel off (2) of brake assembly.
4
- Wrap the basket flap around the rear frame tube and
fasten the 3 snaps.

Assembling the Armbar

WARNING
with the harness. The armbar is not a restraint device.
5
- To attach armbar, insert the armbar into channels on
both sides of the seating area.
6
- To remove, push the buttons on the outside of the
stroller as shown.
7
- Fasten the inner snaps of the seat pad to the inside of
the seating area as shown.
Stroller set up is complete.
14
(1) and pull
Always secure the child
1
brake
lever
2
tab
groove
3
1
2
4
5
6
7
15