Brother GTX-4 Setup Manual page 11

 When installing the printer, avoid any place that presents
direct sunlight or a large amount of dust.
 The body size is 55.1 in. (width) x 51.2 in. (depth) x 21.7 in.
(height) (140 cm (width) x 130 cm (depth) x 55 cm (height))
and the mass weighs 120 kg (265 lb).
 Dimensions of the legs are 34.1 in. (86.7 cm) in width and
16.7 in. (42.3 cm) in depth. The diameter of the legs is 1.57
in. (40mm).
 The height from the table to the top surface of the platen is
approx. 12.6 in. (32 cm).
 Do not use an extension cable.
 Ensure ample work space of over 39.4 in. (100 cm) in front of
and to each side of the printer is available. Also, as a space
to install the rear cover, keep 15.7 in. (40 cm) or wider space
in the back of the printer. Keep 15.7 in. (40 cm) or wider
space in the ceiling direction as well. As the air is exhausted
toward the rear side, keep 7.9 in. (20 cm) or more space from
the exhaust opening.
 The table that supports the printer should be at least 35.4 in.
(90 cm) in width and 23.6 in. (60 cm) in depth, and should be
able to bear a weight of 150 kg (330 lb) or more. The tabletop
should be horizontal and should not rattle when the printer is
running.
 When installing the printer, place a level gauge on the top
surface of the cover and the top surface of the platen to
make adjustments so that the main unit is set horizontally.
 In preparation for a major earthquake or other natural
disasters, fix the table and the main unit with a tool like a
fixing band to prevent the main unit from falling from the
table.
2
Unpacking
Do not turn on the power until "P.5 Removing
the protection materials" is completed.
IMPORTANT
Otherwise the printer may fail.
X0186
2