Function Settings; Active Range; Cleaning Stop - WimTec LOFT HDK Assembly And Operating Instructions Manual

LOFT

Function settings

Active range:

DIP switch 1
'ON' position:
Standard active range (approx. 15 cm, default setting).
'OFF' position: Short active range – (approx. 12 cm, for small washbasins).

Cleaning stop:

DIP switch 2
Serves to disable the fitting prior to cleaning.
'ON' position: Cleaning stop function enabled.
'OFF' position: Cleaning stop function disabled (default setting).
Enable cleaning stop
Approach the infrared sensor
with your hand. The sensor
LED starts flashing, and water
begins to flow from the
faucet.
After flashing 5 times, the
water flow is stopped, and
the cleaning stop is
enabled for 3 min. In this
time the LED flashes 2 times
every 3 s.
Disable cleaning stop
(automatically)
The fitting will resume normal
operation after 3 min.
5 x
Disable cleaning stop
(manual)
To instantly end the cleaning
stop, perform the same steps
used to enable the function.
After flashing 3 times the
cleaning stop is disabled.
3 x
WimTec LOFT
Washbasin fitting
EN
ON
OFF
1 2 3 4 5 6
ON
OFF
1 2 3 4 5 6
3 x
21