Atdec Levitate L-PB Installation Instructions Manual

L-PB
L-PW
Component Checklist
(with pre-assembled Desk Clamp)
Tools Required:
Phillips Head Screwdriver
Power drill
8mm ( / ") drill bit
5
16
IMPORTANT INFORMATION
! IMPORTANT - Install Levitate Single Monitor Arm as per Installation Instructions
! The L-PB and L-PW support weights ranging from of 2kg (minimum) - 8kg (maximum) (4.4 - 17.6lbs).
! This product supports VESA mounting hole configurations 75 x 75mm and 100 x 100mm.
! The manufacturer accepts no responsibility for incorrect installation.

Step 1. Check Components

Check you have received all parts against the Component Checklist and Hardware.

Step 2. Fasten Base to Work Surface - Choose DESK CLAMP OR BOLT THROUGH option

A - DESK CLAMP

The default base setup allows 360° of
rotation of the Lower Arm around the base.
If you want to limit the Lower Arm rotation to
180° go to A1, if not skip to A2.
A1. OPTIONAL 180° ROTATION
To limit the Lower Arm rotation to 180° insert
the Brake Pin underneath the Desk Clamp.
5mm Allen
Key
Remove and re-install the Desk Clamp, using
the 5mm Allen Key supplied. Then go to A2.
Arm Assembly
Cable Covers
(x2 sets)
A2. Position Arm Assembly on the work
surface so that the Desk Clamp hangs over
the edge.
PUSH
Insert
Brake Pin
A3. Using the 5mm Allen Key, close
the Desk Clamp to grip the work
surface. Tighten very firmly.
Desk Clamp
The Clamp Pad will automatically
rotate under the work surface
when tightened.
NOTE: The unique top loading Desk Clamp allows product installation/removal
without having to gain access to the underside of the work surface.
A4. Desk Clamp is now installed, please skip to Step 3 (PTO>>>).

Installation Instructions

Hardware (BAG A)
Security
Screw (x1)
Mounting
Head
M8 x 45mm/60mm
Bolts (x1 each)
Cover Plate
Display Mounting Screws (BAG B)
Base Plate
Clamp Pad
Desk | Single
Bolt Through
Washers (x3)
Spacer
Bush (x4)
M4 x 12mm (x4)
M4 x 16mm (x4)
M4 x 20mm (x4)
TOP LOADING ATTACHMENT
TIP: When sliding the Desk Clamp
between two work surfaces, ensure
that the Clamp Pad is fully open
and parallel with the edge of the
work surface.
Min. gap=18mm
Desk
Clamp
5mm & 2mm
Allen Key
(x1each)
Brake
Pin (x1)
M5 x 12mm (x4)
M5 x 16mm (x4)
(PTO...)
(0.71")
Work Surface
(top view)
TIGHTEN
VERY FIRMLY
(clockwise)