2.7 Jumper Setup
The illustration shows how jumpers are setup. When the jumper cap is placed on
the pins, the jumper is "Short". If no jumper cap is placed on the pins, the jumper
is "Open". The illustration shows a 3-pin jumper whose pin1 and pin2 are "Short"
when a jumper cap is placed on these 2 pins.
ME Recovery Jumper
(3-pin ME_RECOVERY1)
CPU PECI Mode Jumper
(3-pin PECI1)
Flash Descriptor Security
Override Jumper
(3-pin SEC_OR1)
NCSI Mode Jumper
(3-pin NCSI_SEL1)
E3C246D4M-4L / E3C242D4M-4L
Normal Mode (Default)
CPU PECI connect to PCH
Descriptor Security Over-
ride
NCSI is set to onboard
LAN1 (Default)
ME Recovery Mode
CPU PECI connect to BMC
(Default)
Normal Mode (Default)
NCSI is set to Mezzanine
Card
25