Hach RTC101 Basic User Manual page 20

5. Push Add to add more sensors from the list.
Selected sensors show in gray. Refer to
to Figure 6 on page 21 to remove a sensor.
6. Push Enter to accept the list.
Figure 4 Add sensors
1 Select sensor
2 Accept
3 Sensor list
Sort the sensors (RTC modules only)
The sensor sequence is programmed in the RTC module for the measurement values. To sort the
sensors in the order specified for the RTC module, move the selected sensor with the UP and
DOWN arrows. Refer to
Figure 5 Sort the sensors
1 Select sensor
Delete a sensor from the list
To delete a selected sensor from the list, push Delete. Refer to
20 English
Figure 5
Figure 5.
on page 20 to set the sensor sequence. Refer
4 Add
5 Select additional sensor
2 UP and DOWN arrows
Figure 6.