Adjusting The Motion-Control Levers; Converting To Side Discharge - Toro TimeCutter HD X4850 Operator's Manual

Adjusting the
Motion-Control Levers
Adjusting the Height
You can adjust the motion-control levers higher or
lower for maximum comfort
Figure 12
Adjusting the Tilt
You can adjust the motion-control levers forward or
rearward for your comfort.
1. Loosen the upper bolt holding the control lever
to the control-arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever forward or rearward
3. Tighten both bolts to secure the control lever in
the new position.
4. Repeat the adjustment for the other control lever.
Converting to Side
Discharge
The mower deck and mower blades shipped with the
machine were designed for optimum mulching and
side-discharge performance.
Install the fasteners into the same holes in the deck
from where they were originally removed. This
ensures that no holes are left open when operating
the mower deck.
(Figure 12).
g027252
(Figure 12).
WARNING
Open holes in the machine expose you and
others to thrown debris that can cause severe
injury.
• Never operate the machine without
hardware mounted in all holes in the
machine housing.
• Install the hardware in the mounting holes
when you remove the mulching baffle.
Machines with 122 cm (48-inch)
Mower Decks
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the mower deck; refer to
Mower Deck (page
4. Remove the 2 locknuts (5/16 inch) secured to
the welded posts of the left baffle on the top of
the mower deck at the center and left of center
positions (Figure
1. Locknut (5/16 inch)
2. Carriage bolt (5/16 x 3/4
inch)
5. Remove the carriage bolt and locknut on the
side wall of the mower deck securing the left
baffle to the deck.
6. Remove the left baffle from the mower deck as
shown in Figure
7. Remove the 2 carriage bolts (5/16 x 3/4
inch) and 2 locknuts (5/16 inch) securing the
assembled right baffle and baffle guard to the
mower deck (Figure
19
Removing the
54).
13).
Figure 13
3. Left baffle
4. Install the fasteners here.
13.
14).
g011149