Control System - Toro TimeCutter HD X4850 Operator's Manual

Tow
This is the medium speed. The suggested uses for
this speed are as follows:
•
Bagging
•
Mulching
Mow
This is the fastest speed. The suggested uses for this
speed are as follows:
•
Normal mowing
•
Moving the machine
Using the Smart Speed

Control System

For Non-MyRide™ Machines
The Smart Speed TM Control-System lever, located
below the operating position
operator a choice to drive the machine at 3 ground
speed ranges—trim, tow, and mow.
Figure 36
1. Smart-speed lever
To change speeds, do the following:
1. Move the motion-control levers to neutral and
outward to the P
ARK
2. Disengage the blade-control switch.
3. Adjust the lever to the desired position.
The following are only recommendations for use.
Adjustments vary by grass type, moisture content,
and the height of the grass.
Suggested Trim
uses:
Parking X
Heavy, wet X
grass
TM
(Figure 36), gives the
position.
Tow Mow
Training X
Trimming X
grass
Bagging
Mulching
Towing
attachments
Normal
mowing
Moving the
machine
Trim
This is the lowest speed. The suggested uses for this
speed are as follows:
•
Parking
•
Heavy, wet grass mowing conditions
•
Training
•
Trimming grass
Tow
This is the medium speed. The suggested uses for
this speed are as follows:
•
Bagging
•
Mulching
•
Towing attachments
Mow
This is the fastest speed. The suggested uses for this
speed are as follows:
•
Normal mowing
g027625
•
Moving the machine
30
X
X
X
X
X