Removing The Mower Deck - Toro TimeCutter HD X4850 Operator's Manual

Figure 76
1. Deck-lift arm
2. Chain
6. Ensure that there is tension on all 4 chains
(Figure 76).
7. Tighten the 4 adjustment bolts
8. Ensure that the blocks fit snugly under the deck
skirt and that all bolts are tight.
9. Verify that the deck is level by checking the
side-to-side level and front-to-rear blade slope;
repeat the deck leveling procedure if necessary.

Removing the Mower Deck

1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
3. Lower the mower to the 76 mm (3 inches)
height-of-cut position.
4. Loosen the 2 bottom bolts holding the
mower-deck curtain to the mower deck; refer to
Releasing the Mower-Deck Curtain (page
5. Remove the mower belt from the engine pulley;
refer to Replacing the Mower Belt (page
6. Remove the hairpin cotter and washer securing
the link pin to the frame and deck, and remove
the link bar (Figure
3. Hook
4. Adjustment bolt
(Figure 76).
39).
48).
77).
1. Link pin
2. Washer
7. Lift up the mower deck to relieve tension from
the mower deck.
8. Remove the chains from the hooks on the
g024313
deck-lift arms
1. Deck-lift arm
2. Chain
9. Raise the height of cut to the transport position.
10. Remove the belt from the clutch pulley on the
engine.
11. Slide the mower out from underneath the
machine.
Note:
Retain all parts for future installation.
54
Figure 77
3. Hairpin cotter
(Figure 78).
Figure 78
3. Hook
4. Adjustment bolt
g028276
g024313