Control System - Toro TimeCutter HD X4850 Operator's Manual

Figure 33
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion-control
levers rearward (Figure
Figure 34
g008952
34).
g008953
Using the Smart Speed

Control System

For Machines with MyRide™
TM
The Smart Speed
the right of the operating position
you a choice to drive the machine at 3 ground speed
ranges—trim, tow, and mow.
1. Smart-speed lever
To change speeds, do the following:
1. Move the motion-control levers to neutral and
outward to the N
2. Disengage the blade-control switch.
3. Adjust the lever to the desired position.
The following are only recommendations for use.
Adjustments vary by grass type, moisture content,
and the height of the grass.
Suggested Trim
uses:
Parking X
Heavy, wet X
grass
Training X
Bagging
Mulching
Normal
mowing
Moving the
machine
Trim
This is the lowest speed. The suggested uses for this
speed are as follows:
•
Parking
•
Heavy, wet grass mowing conditions
•
Training
29
Control-System lever, located to
(Figure 35), gives
Figure 35
-L position.
EUTRAL OCK
Tow Mow
X
X
X
X
TM
g197125