Table of Contents
Advertisement
Available languages
Available languages
5
2
sec.
04
5
3
sec.
05
single
5
sec.
Note – When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
(*) – WARNING – This deletion must be performed only when you want to adjust the limit switch heights again, using a different procedure than the one used previ-
ously. Whereas if you want to adjust heights with the same procedure, it is not necessary to delete them from memory.
5.10.2 - Procedure performed with an unmemorised transmitter
01. Disconnect power supply from motor.
02. Connect the White and White-black wires to each other.
03. Disconnect power supply from motor.
04. Lastly, perform the procedure indicated in paragraph 5.10.1.
01
02
OFF
Note – When performing the procedure, you can cancel it at any time by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.11 - Locking and unlocking the memory
This procedure allows you to lock or unlock the memory to prevent accidental memorisation of other transmitters not included in the system.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the s key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
04. Keep the s and t keys pressed simultaneously and wait for the motor to perform 2 movements. Upon completion, release the keys.
05. • To unlock the memory: Keep the s key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
• To unlock the memory: Keep the t key pressed and wait for the motor to perform 5 movements. Upon completion, release the key.
01
5
2
sec.
04
5
sec.
Note – When performing the procedure, you can cancel it at
any time by keeping the n and t keys pressed simultane-
ously for 4 seconds. Otherwise, do not press any key and
wait 60 seconds for the motor to perform 6 movements.
7 – English
5
sec.
all
data
key example
(transmitter
3
to be
deleted)
03
white
white-black
02
5
sec.
2
3
05
5
5
sec.
"0"
"1"
"H"
5
04
01
02
ON
Paragraph 5.10.1
Paragraph 5.10.1
3
05
sec.
05
sec.
5
3
sec.
05
all
05
(*)
5
5
sec.
03
04
05
03
5
3
sec.
5
3
5
5
5
Advertisement
Table of Contents
