Table of Contents
Advertisement
Installation
1
3
Figure 9
A Mounting plate
Proceed as follows to install and attach the mounting plate to the AG300:
1 Mark the positions of the mounting points on your end product.
2 Drill out the mounting points.
3 Screw the mounting plate (A) into position using the six mounting points. Use suitable screws
(e.g. ISO 7049 ST3.5 x 25) to attach it to your end product. Make sure that the mounting plate
lies completely flat against its supporting base. This will prevent mechanical forces such as tor-
sion.
4 Place the battery in the lower part of the mounting plate (A). Then push the battery into the up-
per part until the tabs on the battery snap in.
5 You may now connect the battery cable to the battery socket on the drive or control unit.
20
A
Attaching the mounting plate and inserting the AG300
2
4
B
B AG300
AG300
A
81423(-)
Advertisement
Table of Contents
