Table of Contents
Advertisement
AG300
6.2
Installation procedure
Before installing and connecting the AG300, make sure that you are observing all of the safety no-
tices found in the "Safety notices to observe during installation" section.
• The AG300 can be inserted into the holder on the DUOMED or SGAG300.
• The AG300 can be inserted into the mounting plate that is attached to the end product.
6.2.1
Mounting the AG300 to the DUOMED
Work on electrical components should be conducted only when the mains power con-
nection is unplugged.
B
A
Figure 6
A Holder on the drive
C Battery socket on the drive
E cap
Take the following steps when installing the AG300 in the DUOMED:
1 First, insert the battery (F) in the slots on the left side of the holder (A) until the AG300's locking
clips engage.
2 Then snap in the locking clip on the right side of the battery into the right slot on the holder (A).
3 Remove the drive's cap (E) and the dummy plug from the battery socket (C) (if present). Then
connect the AG300 cable (D) to the battery socket (C).
4 Then place the cap (E) back on and secure it.
81423(-)
CAUTION
F
E
Mounting the AG300 to the DUOMED drive
B DUOMED
D Plug for the AG300 connecting cable
F AG300
Installation
C
D
17
Advertisement
Table of Contents
