Figure 57 QSFP28 copper cable
Figure 58 QSFP28 fiber cable
NOTE:
As a best practice, use HPE QSFP28 transceiver modules, QSFP28 cables, QSFP+ transceiver
modules, or QSFP+ cables (except for the QSFP+ to 4 × SFP+ cables) for the QSFP28 ports on the
switch. The HPE QSFP28 transceiver modules or QSFP28 cables are subject to change over time.
For the most up-to-date list of QSFP28 transceiver modules or QSFP28 cables, contact Hewlett
Packard Enterprise Support or marketing staff.
1/10GBASE-T autosensing Ethernet port
The HPE 5710-54HT switch provides 1/10GBASE-T autosensing Ethernet ports.
Table 29 1/10GBASE-T autosensing Ethernet port specifications
Item
Connector type
Port transmission rate
Transmission medium and max
transmission distance
Compatible standards
To avoid interference between cables, layer cables as follows:
•
Use category-6A or above cables and connectors.
•
Do not bundle cables in their first 20 m (65.62 ft).
•
Separate power cords and twisted pair cables at and around the distribution frame.
Specification
RJ-45
1/10 Gbps, full duplex, MDI/MDI-X autosensing
•
55 m (180.45 ft) over category-6 unshielded twisted pair cable
•
100 m (328.08 ft) over category-6 shielded twisted pair cable
•
100 m (328.08 ft) over category-6A or above twisted pair cable
•
IEEE 802.3ab
•
IEEE 802.3an
55