HPE FlexFabric 5710 Series Installation Manual page 14

Align the chassis rails with the rail mounting holes in the chassis:
2.
If the mounting brackets are in the port-side mounting position, align the chassis rails with
the screw holes at the rear of the side panels (see
If the mounting brackets are in the power supply-side mounting position, align the chassis
rails with the screw holes at the front of the side panels (see
and Figure 13).
Use M4 screws (provided) to attach the chassis rails to the chassis.
3.
Figure 8 Attaching the mounting brackets and chassis rails to an HPE 5710-54HF switch
(mounting brackets installed near the port side)
Figure 9 Attaching the mounting brackets and chassis rails to an HPE 5710-54HT switch
(mounting brackets installed near the port side)
Figure 10 Attaching the mounting brackets and chassis rails to an HPE 5710-30HT switch
(mounting brackets installed near the port side)
Figure
10
8, Figure 9, and Figure
Figure 11, Figure 12,
10).