HPE FlexFabric 5710 Series Installation Manual page 42

Figure 44 Rear panel
(1) Fiber management Ethernet port
(3) Console port
(5) Fan tray 1
(7) Fan tray 3
(9) Fan tray 5
(11) Power supply 2
(13) System status LED (SYS)
(15) LINK/ACT LED for the fiber management Ethernet port
An HPE 5710-54HT switch comes with power supply slot PWR1 empty and power supply slot PWR2
installed with a filler module. In
power supply slots. For more information about installing and removing a power supply, see
"Installing and removing a power
An HPE 5710-54HT switch comes with the five fan tray slots empty. You must install five fan trays of
the same model for the switch. In
tray slots. For more information about installing and removing a fan tray, see
a fan tray."
Figure 45 Left side panel
(1) Primary grounding point
(2) Copper management Ethernet port
(4) Mini USB console port
(6) Fan tray 2
(8) Fan tray 4
(10) Power supply 1
(12) USB port
(14) LINK/ACT LED for the copper management Ethernet port
Figure 44, two PSR450-12A1 power supplies are installed in the
supply."
Figure 44, five X721 front-to-back fan trays are installed in the fan
(2) Auxiliary grounding point
38
"Installing and removing