Table of Contents
Advertisement
Quick Links
CLBN 5-18, CLBN 5-21, WPBN 5-18, WPBN 5-21, ISBN 5-18, ISBN 5-21
The aforementioned models have been evaluated and certified according to ANSI Z2160-1996/CGA
2.26-M96 standards by C.S.A. Refer to the attached nameplate on the burner system for cross-
reference of the model number to affirm the correct instruction manual is applicable to your unit.
NOTE!
Installation and service must be performed by a qualified installer, service agent, or the
gas supplier.
ADEQUATE FIREPLACE VENTILATION IS REQUIRED FOR SAFETY.
READ INSTRUCTIONS FULLY BEFORE INSTALLING OR OPERATING.
INSTALLER: LEAVE THESE INSTRUCTION WITH CONSUMER!
Hargrove Manufacturing Corporation uses refractory concrete to create the ceramic logs. Each log is hand
f i r e - p a r t s . c o m
finished to assure the most realistic, detailed logs available. The gas log burner system is designed to
simulate wood burning, with a yellow smoke flame. For this reason the gas log set must be burned only in a
fully vented, non-combustible fireplace with the damper completely open and the chimney free of any
obstruction or restrictions. The fireplace must be designed and approved to burn wood.
The realistic yellow flame produces soot and carbon monoxide. Under normal conditions the bi-products will
exhaust up the chimney. If fumes or soot are evident in the room when the damper is fully open; it indicates
that the fireplace draft is defective. Do not operate your gas log set until the fireplace draft is corrected.
FOR YOUR SAFETY
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity of
this or any other appliance.
FOR YOUR SAFETY
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do
not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone.
supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.
WARNING: If the information in this manual is
not followed exactly, a fire or explosion may
result causing property damage, personal
injury or loss of life.
INSTALLATION AND OPERATION GUIDE FOR
HARGROVE GAS LOGS
PROPANE GAS
For burner/grate accessory models:
21AKBSN1/2CPELP
For the following gas log sets:
Follow the gas
It is the homeowner's responsibility to assure
their fireplace has an adequate draft.
RECOMMENDED BURN-IN PERIOD
Hargrove gas logs are made of refractory
materials, which withstand high temperatures.
One characteristic of this material is moisture
retention.
For this reason, we recommend
burning the log set for only fifteen minutes
during the first burning. After allowing the logs
to cool for at least one hour, the set can be
burned for any length of time.
Hargrove gas logs carry a limited lifetime
warranty against breakage in the original
fireplace. This warranty does not include labor.
This warranty is void if excessive handling after
using the set causes breakage. All accessories
and metal parts carry a two-year limited
warranty in the original fireplace. Hargrove will
replace items during this period for the cost of
shipping.
1
WARRANTY
Advertisement
Table of Contents
Related Manuals for Hargrove CLBN 5-18
Summary of Contents for Hargrove CLBN 5-18
- Page 1 READ INSTRUCTIONS FULLY BEFORE INSTALLING OR OPERATING. INSTALLER: LEAVE THESE INSTRUCTION WITH CONSUMER! Hargrove Manufacturing Corporation uses refractory concrete to create the ceramic logs. Each log is hand f i r e - p a r t s . c o m finished to assure the most realistic, detailed logs available.
- Page 2 4. This appliance must be installed only in a solid fuel burning fireplace with a working flue and constructed of noncombustible material. Solid fuels cannot be used in a fireplace where a Hargrove gas unit has been installed. 5. A permanent free opening must be provided by either the fireplace chimney or chimney damper to vent flue gasses. Any chimney damper must be fixed in such a manner, which will maintain the permanent free opening at all times.
-
Page 3: Factory Built Fireplaces
FIREPLACE SIZES Each gas log set requires a minimum for the front opening, height, and minimum depth. To determine the largest set that will fit in a fireplace, the depth and width are the critical dimensions. The following illustration reflects a view directly above the fireplace looking down. The minimum height for this model is 22 inches. Front Width Depth Rear Width... -
Page 4: Parts List
HARGROVE INSTALLING GAS LOGS PARTS LIST STGN-16 5/8 Pedestal Grate STBN-14 See Thru Burner (Narrow) Vermiculite (LP Gas only) Fire Embers AC-18 Aluminum Connector Concentric Pilot Control RSTPBLP-18 Pilot Burner (LP Gas Only) REG-10.0 Regulator (LP Gas Only) Volcanic Cinders 10. -
Page 5: Gas Connection
DAMPER STOP Attach the damper stop clamp to the fireplace damper blade. Position the clamp to prevent full closure of the fireplace damper blade. (See Figure 1) If the damper stop provided does not fit, the installer shall install a permanent damper stop that will keep the damper open to a minimum of opening as determined in Table II. -
Page 6: Pilot Light
BURNER PAN MEDIA Fill the burner pan with burner media (VM). Burner media level should be sloped evenly with the sides of the burner. Place 2/3 of the PART A Embers on top of the media. Burner should be completely full. -
Page 7: What To Do If You Smell Gas
FOR YOUR SAFEY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury, or loss of life. A. This appliance has a pilot, which C. Use only your hand to push in or turn must be lit by hand. -
Page 8: Limited Warranty
8. Purchaser or user agrees to hold Hargrove Mfg Corp. harmless from any and all claims by the buyer as a result of injury or damage to an ultimate user or other person caused by the product sold herein by the seller to the buyer, whether the injury or damage results from the assembly, installation, operation, shipment, storage, or manufacture of this product.