Table of Contents
Advertisement
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result, causing property damage, personal injury, or loss of life.
A. This appliance has a pilot, which
must be lit by hand. When lighting
the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING: smell around
the appliance area for gas. Be sure
to smell next to the floor because
some gases are heavier than air and
will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
*Do not try to light any appliance.
*Do not touch any electric switch; do not
use any phone in your building.
*Immediately call your gas supplier from
f i r e - p a r t s . c o m
a neighbor's phone. Follow the gas
supplier's instructions.
*If you cannot reach your gas supplier,
call the fire department.
1.
STOP! Read the safety information
above on this label.
2.
Push in gas control knob slightly and turn
clockwise to "OFF".
Control Knob
NOTE: Knob cannot be turned from "Pilot" to
"OFF" unless knob is pushed in slightly. Do not
force the knob.
3. Wait five minutes to clear out any gas. If
you then smell gas. STOP! Follow "B" in the
safety information above this label.
1. Push in gas control knob slightly and turn clockwise to the "OFF" position. Do not force.
FOR YOUR SAFEY READ BEFORE LIGHTING
LIGHTING INSTRUCTIONS
CPE-C
LIGHTING INSTRUCTIONS
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn by
hand, do not try to repair it, call a
qualified service technician. Force or
attempted repair may result in a fire or
explosion.
D. Do not use this appliance if any part
has been under water.
call a qualified service technician to
inspect the appliance and to replace
any part of the control system and or
gas
control,
underwater.
E. Keep the appliance area clear and free
from combustible materials, gasoline
and other flammable liquids.
4. Find the pilot – follow the metal tube from
the gas control to the side of the burner.
Thermocouple
5. Turn knob on gas control counterclockwise
to "PILOT".
6. Push in control knob all the way and hold
in. Immediately light the pilot with a match.
Continue to hold the control knob in for about
one minute after the pilot is lit. Release knob
and it will pop back up. Pilot should remain lit.
If it goes out, repeat steps 3 – 7.
7. Turn gas control knob counterclockwise to
"ON".
7
Immediately
which
has
been
Pilot Burner
Advertisement
Table of Contents
