Hargrove Summit Oak Installation And Operation Manual

Gas logs, propane gas

Advertisement

Quick Links

INSTALLATION AND OPERATION GUIDE FOR
NOTE!
ADEQUATE FIREPLACE VENTILATION IS REQUIRED FOR SAFETY.
GAS LOGS MUST BE INSTALLED BY PERSONNEL QUALIFIED FOR
INSTALLING GAS APPLIANCES.
READ INSTRUCTIONS FULLY BEFORE INSTALLING OR OPERATING.
INSTALLERS LEAVE THESE INSTRUCTIONS WITH THE CONSUMER!
Hargrove Manufacturing Corporation uses refractory material to create ceramic logs. Each log is hand
finished to assure the most realistic, detailed log available. The gas log burner system is designed to
burn like wood with a yellow smokey flame. For this reason the gas log set must be burned only in a
fully vented, non-combustible fireplace with the damper completely open and the chimney free of any
obstructions or restrictions.
minimum permanent, free opening provided by the fireplace chimney must be 8" in diameter (50 square
inches). The realistic yellow flame produces carbon monoxide and soot. Under normal conditions
these products are exhausted up the chimney. If fumes or soot from the gas burning are evident in the
room when the damper is fully open, it indicates that the fireplace draft is defective. Do not operate
your gas log set until the fireplace draft is corrected.
f i r e - p a r t s . c o m
WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE OR
EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF
LIFE.
FOR YOUR SAFETY
FOR YOUR SAFETY
IF YOU SMELL GAS:
IF YOU SMELL GAS:
1. OPEN WINDOWS
1. OPEN WINDOWS
2. DO NOT TOUCH ELECTRICAL
2. DON'T TOUCH ELECTRICAL
SWITCHES
SWITCHES
3. EXTINGUISH ANY OPEN FLAMES
3. EXTINGUISH ANY OPEN FLAMES
4. IMMEDIATELY CALL YOUR GAS
4. IMMEDIATELY CALL YOU GAS
SUPPLIER
SUPPLIER
FLAMMABLE VAPORS MAY BE DRAWN
BY AIR CURRENTS FROM OTHER AREAS
OF YOUR HOUSE TO THIS APPLIANCE.
FOR YOUR SAFETY
DO NOT STORE OR USE GASOLINE OR
OTHER FLAMMABLE VAPORS AND LIQUIDS
IN THE VICINITY OF THIS OR ANY OTHER
APPLIANCE.
HARGROVE GAS LOGS
SUMMIT OAK PROPANE GAS
The fireplace must be designed and approved to burn wood.
IT IS THE HOMEOWNERS RESPONSIBILITY TO ASSURE
THEIR FIREPLACE HAS ADEQUATE DRAFT.
THE SIZE CHART BELOW INDICATES THE
MINIMUM SIZE FIREPLACE OPENINGS IN,
WHICH DIFFERENT SIZE GAS LOG SETS
CAN BE INSTALLED.
FIREPLACE SIZES
GAS LOG
SET SIZE
36"
42"
48"
NOTE:
PERSONNEL QUALIFIED TO INSTALL
GAS APPLIANCES MUST INSTALL GAS LOGS.
WIDTH
DEPTH
28"
44"
28"
50"
28"
56"
The

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Summit Oak and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Hargrove Summit Oak

  • Page 1 READ INSTRUCTIONS FULLY BEFORE INSTALLING OR OPERATING. INSTALLERS LEAVE THESE INSTRUCTIONS WITH THE CONSUMER! Hargrove Manufacturing Corporation uses refractory material to create ceramic logs. Each log is hand finished to assure the most realistic, detailed log available. The gas log burner system is designed to burn like wood with a yellow smokey flame.
  • Page 2 GENERAL INFORMATION DO NOT USE A NATURAL GAS SET FOR PROPANE OR A PROPANE SET FOR NATURAL GAS. A SAFETY PILOT SYSTEM MUST BE INSTALLED PRIOR TO USING THIS APPLIANCE. 1. There are many different local codes for gas fire logs. The installation of this set must conform with local codes or, in the absence of local codes, to the National Fuel Gas Code ANSI Z223.1 1999.
  • Page 3 UNIT POSITION WARNING: Warranty is void if the RSBMV-C is installed behind the burner 1. Turn gas off. pan in the fireplace. 2. Remove old log lighter, ashes, and other material from the firebox. WARNING: Valves may not shut off if 3.
  • Page 4 WALL SWITCH INSTALLATION 1. To install a wall switch, mount a standard 3”x 2” electrical box in wall near the fireplace. Run thermostat wire (18 gauge wire) from the electrical box to the millivolt valve. At the valve, the lead wires should be connected to the two outside terminals labeled “TH”.
  • Page 5 LOG PLACEMENT 1. The longest log is the middle log. It should be placed on the center pedestals of the grate with the flat, unfinished side facing down. Assure that the log does not restrict the ignition porting of the BB – 27 burner that angles toward the front and directly behind the log.
  • Page 6 8. Purchaser or user agrees to hold Hargrove Mfg Corp. harmless from any and all claims by the buyer as a result of injury or damage to an ultimate user or other person caused by the product sold herein by the seller to the buyer, whether the injury or damage results from the assembly, installation, operation, shipment, storage, or manufacture of this product.

Table of Contents