Hargrove RMBE-PO Installation Manual

HARGROVE VENTED GAS LOGS
High Capacity Millivolt Gas Valve (RMBE-PO)
Installation and service must be provided by a qualified installer, service agency or the gas supplier.
FOR YOUR SAFETY
WHAT TO DO IF YOU SMELL GAS
1. Open windows.
2. Extinguish all open flames.
3. Do not try to light any appliance.
4. Do not touch any electrical switch; do
not use the phone in your building.
5. Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
6. If you cannot reach your gas supplier,
call the fire department.
WARNING
To avoid a potential fire hazard, do not
disassemble or attempt to repair the safety
gas valve. Disassembly, reassembly or
internal adjustment could cause the valve
to malfunction, resulting in property
damage, personal injury, or death. If the
control valve does not operate properly
following the installation or service,
replace the unit.
FOR YOUR SAFTEY
DO NOT STORE OR USE GASOLINE OR
OTHER FLAMMABLE
FLAMMABLE VAPORS IN THE VICINITY OF
THIS OR ANY OTHER APPLIANCE
WARNING:
If you do not follow these instructions exactly, a fire or explosion may
occur resulting in property damage, personal injury, or loss of life.
INSTALLATION GUIDE FOR
LIQUIDS OR
.
FOR YOUR SAFETY
CAUTIONS
1. This valve should be installed only by
a qualified service technician trained
in gas safety equipment.
2. Turn off the gas supply before
installing the valve.
3. All piping must meet applicable local
codes and ordinances and the
National Fuel Gas Code (ANSI
Z223.1/NFPA NO.54)
4. All wiring must meet the applicable
electrical codes and ordinances.
5. Assure that the complete system is
operating according to the
manufacturer's instructions after
installing the Parts Only Kit.
6. Prior to installation, verify
conformance with the log unit's
installation instructions.
7. Assure that all the piping is free of
any foreign matter.
INSTALLING A HARGROVE SAFETY GAS VALVE
IN A LOCATION OTHER THAN SPECIFIED IN THIS
MANUAL WILL VOID THE WARRANTY EXCEPT
WHEN THE SAFETY GAS VALVE IS INSTALLED
OUTSIDE THE FIREBOX IN A SAFE AND PROPER
INSTALLATION AND ACCESS IS PROVIDED FOR
MAINTENANCE AND REPAIR OF THE SYSTEM. A
QUALIFIED INSTALLER MUST MAKE
INSTALLATION AND ADJUSTMENTS.
PO
REV 081716