1MRK 514 027-UEN D
5.3.3.2
Mounting procedure for wall mounting
Figure 5:
5.3.3.3
How to reach the rear side of the IED
The IED can be equipped with a rear protection cover recommended to be used with this type
of mounting. See figure 6.
To reach the rear side of the IED, a free space of 80 mm is required on the unhinged side.
IEC06000135 V3 EN-US
Figure 6:
PosNo
1
2
3
650 series
Installation manual
Use only the screws included in the mounting kit when mounting the plates and
the angles on the IED. Screws with wrong dimension may damage the PCBs
inside the IED.
If fiber cables are bent too much, the signal can be weakened. Wall mounting is
therefore not recommended for any communication modules with fiber
connection.
Wall mounting details.
80 mm
How to reach the connectors on the rear side of the IED.
Description
Screw
Screw
Rear protection cover
© Copyright 2017 ABB. All rights reserved
3
1
IEC06000135-2-en.vsd
Type
M4x10
M5x8
(Ordered separately)
Section 5
Mounting
M11949-2 v3
M11941-2 v5
2
23