Flush Mounting; Overview - ABB Relion 650 Series Installation Manual

Section 5
Mounting
A
IEC15000446 V2 EN-US
Figure 2: Different mounting methods
Description
A

Flush mounting

B 19" Panel rack mounting
C Wall mounting
D Side-by-side rack mounting
5.3.1 Flush mounting
5.3.1.1

Overview

The flush mounting kit can be used for the 1/2 x 19" case size.
Only a single case can be mounted in each cut-out on the cubicle panel, for class IP54
protection. The screws from the IED shall be used to fasten the fasteners to the IED.
20
B
Flush mounting cannot be used for side-by-side mounted IEDs when IP54 class
must be fulfilled. Only IP20 class can be obtained when mounting two cases
side-by-side in one (1) cut-out.
To obtain IP54 class protection, an additional factory mounted sealing must be
ordered when ordering the IED.
© Copyright 2017 ABB. All rights reserved
C
1MRK 514 027-UEN D
D
IEC15000446-2-en.vsdx
IP10303-1 v1
M11967-3 v5
650 series
Installation manual