Table of Contents
Advertisement
COMBO HEADSET
5. If there is no dial tone or
you cannot hear the sound
of your blowing, move the
switch through positions A-
G until you can hear a dial
tone and the sound of your
blowing. Most phones will
use Position A (Figure 3-11).
A
G
B
F
C
D E
Figure 3-11. Position A.
6. Press the mute button on
the outside of the receiver
to exit the headset set-up
mode. (If you forget, the
headset will automatically
exit the setup mode after 10
14
seconds.) A signal will
indicate that you are exiting
setup mode. If the headset
exits setup mode before you
have found the correct
setting, you need to enter
setup mode again as
described (Figure 3-10).
Figure 3-12. Replacing the Earplate and
Ear Cushion.
7. Put the earplate back in
place by mounting it at a 45°
angle to the right. Then
press the earplate down and
turn it clockwise (Figure
3-12).
3.3.2 S
2: A
TEP
DJUSTING THE
MICROPHONE SOUND LEVEL
The microphone sound level must
be set according to your model of
telephone for the party on the
other end to hear you clearly. This
typically only needs to be adjusted
once during set-up.
1. Put on the headset. Call
someone and ask for help
adjusting the sound level of
your microphone.
2. Press and hold mute button
for 3 seconds to enter set-up
mode. You will hear a signal
when the headset is in the
setup mode (Figure 3-13).
Advertisement
Table of Contents
