FCC INFORMATION FEDERAL COMMUNICATIONS COMMISSION INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication. It has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection against such interference...
Page 3
ELITE HEADSETS (MONAURAL AND BINAURAL) FCC REQUIREMENTS FOR TELEPHONE-LINE EQUIPMENT 1. The Federal Communications Commission (FCC) has established rules which permit this device to be directly connected to the telephone network with standardized jacks. This equipment should not be used on party lines or coin lines. 2.
Page 4
FCC INFORMATION 5. If the telephone company requests information on what equipment is connected to their lines, inform them of: a. The telephone number that this unit is connected b. The ringer equivalence number. c. The USOC jack required: RJ-11C. d.
Page 5
ELITE HEADSETS (MONAURAL AND BINAURAL) ELITE HEADSETS (MONAURAL AND BINAURAL) CERTIFICATION NOTICE FOR EQUIPMENT USED IN CANADA The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunications- network protective, operation, and safety requirements. The Department does not guarantee the equipment will operate to the user’s satisfaction.
Page 6
CDC NOTICE Repairs to certified equipment should be made by an authorized Canadian maintenance facility—in this case, your supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.
ELITE HEADSETS (MONAURAL AND BINAURAL) ELITE HEADSETS (MONAURAL AND BINAURAL) NORMAS OFICIALES MEXICANAS (NOM) ELECTRICAL SAFETY STATEMENT INSTRUCCIONES DE SEGURIDAD 1. Todas las instrucciones de seguridad y operación deberán ser leídas antes de que el aparato eléctrico sea operado. 2. Las instrucciones de seguridad y operación deberán ser guardadas para referencia futura.
Page 8
NOM STATEMENT 10. El equipo eléctrico deber ser situado fuera del alcance de fuentes de calor como radiadores, registros de calor, estufas u otros aparatos (incluyendo amplificadores) que producen calor. 11. El aparato eléctrico deberá ser connectado a una fuente de poder sólo del tipo descrito en el instructivo de operación, o como se indique en el aparato.
ELITE HEADSETS (MONAURAL AND BINAURAL) ELITE HEADSETS (MONAURAL AND BINAURAL) TRADEMARKS USED IN THIS MANUAL UL is a registered trademark of Underwriters Laboratories Incorporated. Any other trademarks mentioned in this manual are acknowledged to be the property of the trademark owners.
CHAPTER 1: Specifications 1. Specifications Transmit Distortion: Less than 5% Frequency Response: 300 to 3000 Hz Microphone: Noise-canceling electret Power: Current consumption: <200 µa @ 1.5 VDC; Operating voltage: 1.5 to 10 VDC Receive Automatic Gain Control (AGC): Threshold level with amplifier: -41 dBV with 1 kHz input Frequency Response: 300 to 3000 Hz Input Impedance: 300 ohms...
Page 11
ELITE HEADSETS (MONAURAL AND BINAURAL) ELITE HEADSETS (MONAURAL AND BINAURAL) General Compliance: Registered to UL ® 1459; FCC Part 68 registered; OSHA Part 1910 subpart S; CSA C22.2 No. 225-M90 Weight: Monaural: 2.53 oz. (71.7 g); Binaural: 3.52 oz. (100 g)
Page 12
CHAPTER 2: Monaural Elite Headset 2. Monaural Elite Headset Your Monaural Elite Headset should look like the one in the illustration below. Components are described in the illustration. Adjustable StayPut headband Support plate Receiver with foam cover Microphone with foam cover Microphone boom arm Clothing clip...
Page 13
Disconnect provided with the amplifier or bottom cord that plugs into your phone. Place and receive calls according to the amplifier or telephone instructions. NOTE Extra foam speaker covers are available. If you’d like to purchase them, call Black Box at 724-746-5500.
Page 14
CHAPTER 3: Binaural Elite Headset 3. Binaural Elite Headset Your Binaural Elite Headset should look like the one in the illustration below. Components are described in the illustration. Adjustable StayPut headband Receivers with foam covers Microphone with foam cover Microphone boom arm Clothing Clip 1.
Page 15
Disconnect provided with the amplifier or bottom cord that plugs into your phone. Place and receive calls according to the amplifier or telephone instructions. NOTE Extra foam speaker covers are available. If you’d like to purchase them, call Black Box at 724-746-5500.
Cautionary Notes Cautionary Notes to Computer Users When using any headset with a computer, care should be taken in dry or low-humidity environments to protect the user from electrostatic discharge from the monitor (CRT). Computer monitors can induce a substantial electrostatic charge when turned on or off, or when there is a power failure, and the resulting electrostatic discharge can be passed through the headset to ground.
Page 17
ELITE HEADSETS (MONAURAL AND BINAURAL) To minimize the possibility of electrostatic discharge through the headset, you can: • Use a grounded screen in front of the monitor. • Use static-dissipative wrist straps. • Increase the relative humidity in the room to 60% or more.
CHAPTER 4: Troubleshooting 4. Troubleshooting 4.1 Calling Black Box If you determine that your Elite Headset is malfunctioning, do not attempt to alter or repair the unit. It contains no user-serviceable parts. Contact Black Box at 724-746-5500. Before you do, make a record of the history of the problem.
Page 19
ELITE HEADSETS (MONAURAL AND BINAURAL) 4.2 Shipping and Packaging If you need to transport or ship your Elite Headset: • Package it carefully. We recommend that you use the original container. • If you are shipping the Elite Headset for repair, make sure you include everything that came in the original package.