Table of Contents
Advertisement
Figure 3-8. Inserting the Battery Adapter
into the Battery Chamber.
NOTE
Battery life varies with usage.
The typical life of the 3032
battery is 600 hours. The
typical life of the 2032 battery
is 200 hours.
3.3 Setup
IMPORTANT
You must complete the follow-
ing two steps before operation.
You only need to follow these
steps once for your phone. If,
however, you use a different
phone, you will need to repeat
these steps.
3.3.1 S
1: A
TEP
DJUSTING TO YOUR
TELEPHONE
1. To set up the headset to
your telephone, you need to
adjust the termination
switch. To do so, remove the
earplate and ear cushion
from the receiver by turning
the earplate 45° counter-
clockwise. The telephone
termination switch, marked
A – G, is now visible (Figure
3-9).
A
B
C
Figure 3-9. Telephone Termination Switch.
2. Press and hold the mute
button on the outside of the
receiver for 3 seconds. After
3 seconds you will hear a
signal indicating the headset
is now in setup mode
(Figure 3-10).
Figure 3-10. Pressing the Mute Button.
3. Put the headset receiver to
your ear. Lift the handset
from the telephone and
listen for a dial tone in your
headset.
G
F
D E
4. If you hear a dial tone, blow
into the microphone. If you
can hear the sound of your
blowing, the setting is
correct.
CHAPTER 3: Installation
13
Advertisement
Table of Contents
