Page 2
FCC INFORMATION FEDERAL COMMUNICATIONS COMMISSION INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication.
Page 3
PRO-FIT MOBILE HEADSET FCC REQUIREMENTS FOR TELEPHONE-LINE EQUIPMENT 1. The Federal Communications Commission (FCC) has established rules which permit this device to be directly connected to the telephone network with standardized jacks. This equipment should not be used on party lines or coin lines. 2.
Page 4
CDC STATEMENT Items (b) and (d) can be found on the unit’s FCC label. The ringer equivalence number (REN) is used to determine how many devices can be connected to your telephone line. In most areas, the sum of the RENs of all devices on any one line should not exceed five (5.0).
Page 5
PRO-FIT MOBILE HEADSET CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. The LOAD NUMBER (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which is used by the device, to prevent overloading.
Page 6
NOM STATEMENT 7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado por el fabricante. 8. Servicio—El usuario no debe intentar dar servicio al equipo eléctrico más allá a lo descrito en las instrucciones de operación.
Page 7
PRO-FIT MOBILE HEADSET 17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre la cubierta u orificios de ventilación. 18. Servicio por personal calificado deberá ser provisto cuando: A: El cable de poder o el contacto ha sido dañado; u B: Objectos han caído o líquido ha sido derramado dentro del aparato;...
Page 8
TRADEMARKS USED IN THIS MANUAL TRADEMARKS USED IN THIS MANUAL is a registered trademark of Underwriters Laboratories Incorporated. ® Any other trademarks mentioned in this manual are acknowledged to be the property of the trademark owners.
If after reviewing this guide you have any questions concerning the Pro-Fit Mobile Headset, please 2.1 About This Guide call Black Box Technical Support This guide contains instructions at 724-746-5500. for the Pro-Fit Mobile Headset. To derive maximum benefit from this 2.2 Pro-Fit Mobile Headset...
CHAPTER 3: Flexible Earhook 3. Flexible Earhook To put on your new Pro-Fit the uppermost part of your ear. Mobile earhook (see Figure 3-2): The Pro-Fit Mobile Headset 3. Adjust the flexible hook comes out of the box with the with your thumb until it flexible earhook installed (see rests comfortably along the...
PRO-FIT MOBILE HEADSET 180° and swing the earhook the swivel stem notch over the mounting post on the around to the other side of the receiver (see Figure 3-5). speaker (see Figure 3-3). Figure 3-4. Removing Earhook. 2. Place both your thumbs on the center of the receiver Figure 3-5.
CHAPTER 4: Earloop 4. Earloop 4.1 Installation 1. Remove the earhook or The Pro-Fit Mobile Headset can headband. be fitted with a choice of earloop sizes. An earloop completely 2. Select the desired earloop encircles the ear and positions the size.
PRO-FIT MOBILE HEADSET 4.3 Changing Ears 2. Position the back of the earloop behind the ear and No adjustments are necessary. gently pull forward until the Simply turn the headset over to speaker rests on the ear. wear on the opposite ear. Refer to the Microphone Positioning section (Chapter 6) for additional 4.4 Wearing the Earloop...
CHAPTER 5: Headband 5. Headband The Pro-Fit Mobile Headset can also be equipped with a fully adjustable, lightweight headband. 5.1 Installation Figure 5-2. Headband Removal. 1. Remove the earhook or earloop. 2. Position your fingers behind the outer portion of the 2.
PRO-FIT MOBILE HEADSET Figure 5-3. Changing Ears. Figure 5-4. Headband Wearning. 5.4 Wearing the Headband Refer to the Microphone Positioning Position the headset lightly on section (Chapter 6) for additional your head (see Figure 5-4). The information. Stay-Put click-stop headband lengthens and shortens to the desired length for a custom fit (pull to lengthen, push to...
CHAPTER 6: Microphone Positioning 6. Microphone noise and is better suited for noisy environments. Position the Positioning microphone properly to take advantage of the noise-canceling For the Pro-Fit Mobile Headset, qualities of this microphone. the microphone boom should be adjusted so that the microphone Your Pro-Fit Mobile Headset has a is approximately one-half inch (12 flexible microphone boom:...
PRO-FIT MOBILE HEADSET 7. Clothing Clip The clothing clip should be fastened for comfortable wearing (see Figure 7-1). It is designed to prevent the weight of the cord from dislodging the headset. Figure 7-1. Clothing Clip. Position the clip conveniently on your clothing.
2.5 mm port with this size port (see Figure 8-1). Figure 8-2. Mobile Phone Connection Using an Optional Adapter. Call Black Box at 724-746-5500 for details. Figure 8-1. Mobile Phone Connection. For many mobile telephones without built-in headset ports, optional adapters are available...
PRO-FIT MOBILE HEADSET 9. Maintenance A user in close proximity to or • Install static-dissipative carpets or floor coverings touching the computer may feel a The foam covers on the headband (anti-static sprays can be common “shock” sensation, helpful). and microphone can be washed in similar to touching a doorknob mild soap and water.
• the nature and duration of package. Before you ship, the problem. contact Black Box to get a Return Materials • when the problem occurs. Authorization (RMA) number. • the components involved in...
Page 23
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500) FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746 Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018 Web site: www.blackbox.com • E-mail: info@blackbox.com...