Cisco 6130 NI-1 Conversion Procedure page 39

Remove the DS3 STM
Complete the following steps to remove the DS3 STM from the Cisco 6130 chassis:
Open the front cover on the Cisco 6130 chassis.
Step 1
Lift up on the ejector tab of the DS3 STM. This action disconnects the module from the backplane.
Step 2
Carefully slide the module out of the slot.
Step 3
Remove the System Controller Card
Complete the following steps to remove the system controller card from the Cisco 6130 chassis:
Step 1 Lift up on the ejector tab of the system controller card. This action disconnects the card from
the backplane.
Step 2 Carefully slide the card out of the slot.
Remove the NI-1 Card
This section provides the removal procedures for the DS3 and the OC-3c NI-1 cards.
Removing a DS3 NI-1 Card
Caution Proper ESD protection is required whenever you handle Cisco DSLAM equipment.
Installation and maintenance personnel should be properly grounded using ground straps
to eliminate the risk of ESD damage to the equipment. Cards are subject to ESD damage
whenever they are removed from the chassis.
Complete the following steps to remove a DS3 NI-1 card from the Cisco 6130:
Step 1 Lift up on the ejector tabs of the DS3 NI-1 card. This action disconnects the card from the backplane.
Step 2 Carefully slide the card out of the slot.
78-10709-03
Cisco 6130 NI-1 to NI-2 Conversion Procedures
Cisco 6130 NI-1 to NI-2 Upgrade Kit Conversion Procedures
39