Cisco 6130 NI-1 Conversion Procedure page 18

Cisco 6130 NI-1 to NI-2 Conversion Procedures
NI-1 to NI-2 Migration Utility Output Files
The NI-1 to NI-2 migration utility creates the following output files:
•
•
Note
Run the NI-2 Preparation Build
Complete the following steps to run the NI-2 preparation build:
Caution The procedure that is outlined in the following steps will force the Cisco 6130 system to
stop providing DSL service for the duration of the conversion procedures. Do not proceed
unless this is acceptable.
Proper ESD protection is required whenever you handle Cisco DSLAM equipment.
Caution
Installation and maintenance personnel should be properly grounded using ground straps
to eliminate the risk of ESD damage to the equipment. Cards are subject to ESD damage
whenever they are removed from the chassis.
Step 1 Insert the Cisco NI-1 to NI-2 Line Card Upgrade Utility CD.
The CD contains the 3.0.0.A.rdf file along with images for the system controller card, 4xflexi line cards,
and the 4xSDSL line cards.
Step 2 Copy the .rdf and image files to the appropriate Windows or UNIX directories.
For Windows, copy the files into the folder where your program files are stored. For UNIX, copy the
image files into the /tftpboot/ directory and the .rdf file into the /opt/CSCOvrovs/RDF/ directory.
Step 3 Upgrade the Cisco 6130 system node software to Release c6100-3.0.0.A.
Note
The upgrade is successful and complete when the STATUS, ACTIVE, and four port LEDs are solid
green on the 4xflexi and 4xSDSL line cards. The 4xflexi and 4xSDSL line cards will now boot in both
an NI-1 or an NI-2 system.
Cisco 6130 NI-1 to NI-2 Upgrade Kit Conversion Procedures
18
-c Config file - with path. If you do not specify a path, the utility assumes that the path is the same
as the path for the NSS file, but with a .CFG extension.
-r Report file - with path. If you do not specify a path, the utility assumes that the path is the same
as the path for the NSS file, but with a .TMP extension.
If the utility cannot find one or more of the input files, or cannot create one or more
of the output files, the utility exits with an error.
For detailed node upgrade procedures, refer to either the ViewRunner for Windows
User Guide or the ViewRunner for HP OpenView User Guide.
During the upgrade process you may receive a warning that certain hardware
revisions were found in the Cisco 6130 but not listed in the .rdf file. This warning
is followed by a list of the hardware revisions. This list refers to the cards that were
removed from the chassis in Step 1. This is an expected response. Click Next or
Ok to continue.
78-10709-03