Cisco 6130 NI-1 Conversion Procedure page 33

Install the New System I/O Card
Complete the following steps to install the new system I/O card on the chassis backplane:
Use a one-quarter inch socket driver or wrench to attach nine standoff screws into the locations that are
Step 1
shown in Figure 13. Tighten the standoff screws using the one-quarter inch socket driver or wrench.
Caution Be careful when you remove the standoff screws and reinsert the screws into the screw
holes on the backplane so that the backplane circuitry does not become damaged.
Figure 13
78-10709-03
Standoff Screw Locations for the System I/O Card Installation
P14 P15 P17
E2A VISUAL AUDIBLE
J42
J46
MODEM
POOL
B
OUT
J49
J43
ANALOG TEST I/F
RING
J44
TIP
P18
Cisco 6130 NI-1 to NI-2 Conversion Procedures
J45
MODEM
POOL
A
OUT
P13
J39
P9 P3
J47
U1
J41
Cisco 6130 NI-1 to NI-2 Upgrade Kit Conversion Procedures
J40
33