Cisco 6130 NI-1 Conversion Procedure page 30

Cisco 6130 NI-1 to NI-2 Conversion Procedures
Hook one end of the copper wire around the screw on the rack.
Step 5
Tighten the rack screw over the copper wire.
Step 6
Note
Loosen the compression screw that is provided on the grounding lug of the Cisco 6130.
Step 7
The grounding lugs are located in the upper left corner of each chassis (viewed from the rear).
Insert the other end of the copper wire under the compression screw.
Step 8
Tighten the compression screw over the copper wire.
Step 9
Note
The left side of Figure 11 shows how to ground the Cisco 6130 chassis.
Figure 11
Rack
Connect the Cisco 6130 to the Cisco 6120
Connect the one-to-two Champ cables from the Cisco 6100 (connectors J39 through J44) to the
Cisco 6120 (connectors J1 through J6). Table 3 shows the corresponding Cisco 6100 and Cisco 6120
connectors when two Cisco 6120 chassis are used.
Table 3
Cisco 6100
Connector
J39
J40
J41
J42
J43
J44
Cisco 6130 NI-1 to NI-2 Upgrade Kit Conversion Procedures
30
You can use a lug terminal to connect the grounding wire to the rack.
Do not ground the components in a rack by chaining them together.
Grounding the Cisco 6130 Chassis
Cisco 6100/6130
Cisco 6100 and Cisco 6120 Corresponding Connectors
First
Cisco 6120
Connector
J3
J1
J5
J4
J2
J6
Second
Cisco 6120
Connector
J3
J1
J5
J4
J2
J6
78-10709-03