Page 1
SIGNAL SIGNAL SIGNAL User Instructions This booklet contains important information concerning the proper and safe operation of your new amplifier. Index MT-Series MT-600Q Made in Taiwan 02 Important Precautions Introduction 03 Front Panel 04 Rear Panel 05 Set Up 07 Operating Modes...
Page 2
UNiKA MT-600Q This symbol is intended to alert the user to the presence of This symbol is intended to alert the user of non insulated "dangerous voltage" within the product's the presence of important operating and CAUTION enclosure that may be of sufficient magnitude to constitute...
Specifications IMPORTANT PRECAUTIONS INTRODUCTION To reduce the risk of electrical shock or fire, do not expose this unit rain or Congratulations and thank you for purchasing MT-600Q amplifier. This moisture. amplifier is representation of UNiKA’s continuing commitment to produce ...
Figure 1 1. Standard 19" rack mounting holes are provided on the front panel. 10. AC Power Switch - MT-600Q power amplifier has a front-panel AC mains power switch. 2. Cooling Vent - These vents are used for proper cooling. Never block these vents when installing the amplifier or other associated equipment and keep them clean 11.
UNiKA MT-600Q Rear Panel Important Precautions Introduction Front Panel Set Up Operating Modes Protection Specifications MT-600Q REAR PANEL BALANCED INPUTS ATTENTION: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR CH 3 CH 1 CH 1/2 Tip=(+) Ring=(-) 120VAC 8 Ohms...
Page 6
INPUTS - The MT-600Q amplifier allows you to use two types of input connectors per channel, the EuroBlock input connectors and 1/4” TRS female jack that will accept balanced audio signal. Use these connections to connect the output signal from a mixer, cross-over or EQ to the MT-600Q amplifier.
Page 7
UNiKA MT-600Q Set Up Important Precautions Introduction Front Panel Rear Panel Operating Modes Protection Specifications BANANA PLUG: (Figure 5) When connecting your speakers to the amplifier using banana plug, be sure that the red and black caps on the binding post are completely screwed in. Insert the banana plug into the caps of the binding post, be sure Figure that the banana plug is inserted securely to avoid the risk of popping out.
UNiKA MT-600Q Operating Modes Important Precautions Introduction Front Panel Rear Panel Set Up Protection Specifications OPERATING MODES STEREO OPERATION : Connect your inputs into channel one and channel two, also channels three and four of the amplifier . Connect your speakers to the outputs on the rear of the amplifier.
2. The MT-600Q’s external heatsinks do most of the work in getting heat away from the amplifier, in normal operation. A rear mounted variable speed fan provides extra cooling of the amplifiers internal circuitry as needed. Normally, at low to moderate signal levels, the fan runs at a low speed idle. If the internal temperature rises above a set level then the fan switches to a higher speed to remove more heat from the inside.
UNiKA MT-600Q Specifications Important Precautions Introduction Front Panel Rear Panel Set Up Operating Modes Protection SPECIFICATIONS MT-600Q Dimensions 1.75”H x 19.0” W x 13.5”D ; 44.5mm x 482.6mm x 190.5mm Weight 19.8 lbs., 9.0kg. Input Connections ¼” TRS (balanced/unbalanced); Euroblock (balanced/unbalanced)
Page 11
UNiKA MT-600Q Important Precautions Introduction Front Panel Rear Panel Set Up Operating Modes Protection Specifications page 10...